Ok guys, looking for a little help on this one. I am replacing the stock Infinity speakers with new infinity speakers. Only problem is I cant seem to figure out which wire goes to the crossover for the component speakers. I googled and came up with this site: http://www.modifiedlife.com/2002-dodge-durango-car-radio-wiring-diagram/
None of my wiring matches up. Are these colors right and I need to start digging in the wiring harness itself? Or can I just use the ends that ran to the mid-bass speaker.
Does the factory head unit automatically split the highs from the lows and run it to them, or did both factory speakers split the full throughput and just play what they can?
I have connected the rear speakers via the mid-bass speaker wire and it seems to play fine, but before I put everything back together, I was wanting a definitive answer.
Thanks, in advance, for the help.
~Mark
None of my wiring matches up. Are these colors right and I need to start digging in the wiring harness itself? Or can I just use the ends that ran to the mid-bass speaker.
Does the factory head unit automatically split the highs from the lows and run it to them, or did both factory speakers split the full throughput and just play what they can?
I have connected the rear speakers via the mid-bass speaker wire and it seems to play fine, but before I put everything back together, I was wanting a definitive answer.
Thanks, in advance, for the help.
~Mark