[cooldude117]

Like the title says, will the roll bar off of a genII fit a gen III? I think I might have found one, but I'm not sure if it will fit. Or if someone has some measurments of the bed width (inside of rail to inside of rail) , rail width, and height of cab (from top of box to center of cab) That would be much appreciated.

Here's a pic so you know the style I'm looking at.

 

[cooldude117]

Can anyone with a genII get the box measurements for me? Thanks!

 

[Little Blue Guy]

What you want, box width?

 

[Little Blue Guy]

Looks like 60" give or take from center to center of side bed rails on top

 

[cooldude117]

Thanks, what is it between the inside edges of the rails and how high is the cab above the box.

 

[Little Blue Guy]

Thanks, what is it between the inside edges of the rails and how high is the cab above the box.

57-1/2" inside to inside.....approx 20" from bed rail to top of cab at it's highest point...roof has a curve to it...

 

[cooldude117]

Sweet! Thanks very much! That's exactly what my gen 3 measures up as.

 

[cooldude117]

Well, I just recieved the light bar that I won off of ebay. It looks like this is going to work almost perfectly. :mullet: There's going to be a few challenges to it, but will be pretty slick once it's all done. Here's some pics from my mock-up.

I threw a spare tire in the back where I want to build a spare tire mount in the bed. It will sit slightly higher but at the same angle when it's finished. :mullet:

I'll keep updating this thread as this mod progresses.