Dakota Durango Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
i have the 568xv alarm on my 98 CC, and i am having trouble with the driver's side power lock. i hit the button on the driver's door to lock and it just clicks, but when i hit unlock, it unlocks. the passenger door both lock and unlock work fine as well as when i use the factory remote for either function. the viper remote will arm/disarm the alarm and will unlock the doors, but not lock them. when the 568xv was installed i also needed a "5 wire" adapter for the locks to work with the alarm. i know my driver's switch is good because it was already replaced to solve the problem and it made no difference. i think the solenoid is ok because i hear the clicking. i know that the 2 wires from the drivers locking switch are the orange/violet and the pink/violet wires. i sorta traced them back into the dash but dont see any issues. i was hoping someone on here has the wiring diagram for the 568xv and the separate diagram for the 5 wire adapter. any help is appreciated!
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #7 ·
where is that located? but would that be it if the factory remote and the passenger side lock button lock both doors?
 
1 - 7 of 7 Posts
Top