Dakota Durango Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,602 Posts
I cut the shifter in my 03 dodge ram 5-speed. Cut 3" out of the middle of it and welded it back up. The cut and weld was under the boot so you couldn't see it and I used my stock shift knob.
cutting it about the pivot ball does nothing...now if you cut below the pivot ball,add some material this moving the pivot ball up,you get a shorter throw.

A few guys in the j-body scene have done this because short shifters for cavaliers and sunflowers are no longer made.

Get creative man.:mullet:
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top