[TheOtherDodge]

For my 5.2 based stroker, I need some blower pistons to give me about 8:1 compression. I don't have the motor apart so I don't know the bore size and I am assuming stock rod lengths.

Where is a good source to get these? I want a piston with the thickest top and the top ring land as far down as possible.

 

[TheOtherDodge]

Hughes has some that will give 8.6:1 which I will take a closer look at once I pull my motor apart to see the actual specs of it.

I want to run lots of boost on pump gas (15 psi) and just to be safe...

 

[TheOtherDodge]

This is for the 94, not my 2000.

I will be using a 76 mm turbo and I think I will go with some 8.6:1 blower pistons Hughes Engine sells.

 

[TheOtherDodge]

Fast360: Where did you get them and what is the price and part number?

Is your build done yet? If so, how does it run? If you could do it again, would you run closer to 9-9.5:1 compression?