[commeeche]

Hey guys,
I have done some work to the back, I've taken off the rear bumper and hitch for a rollpan, and the spare tire I took out for the dual exhaust, I found that now because of the weight loss the back sits more higher up, which I expected, but I would like to to match the front height wise, and I was wondering if I can buy just a rear lowering kit? whether it be lowering blocks or something else, any ideas would help

 

[Big_Texxan]

yea, you can raise the front with a lift, or lower the back with some blocks. Either way just depends on your preference

 

[commeeche]

I have a 2wd, if I had a 4x4 I'd lift for sure, now can I buy the lower blocks separate? I've only seen them in kits that include the front lower kits, I assume somewhere someone does

 

[Big_Texxan]

Autozone has some blocks you can get, but look around also, they should be leveling, if worse came to worse, but the 2/4 kit and lower the rear only.

 

[commeeche]

good point, then I could sell the front maybe if I don't use it, and I'll check around, Thanks texxan +1 for you

 

[Big_Texxan]

no problemo man. thank ya

 

[FrenicX]

man.. you guys are lucky to be axle over spring. I'd love to have just a cunt hair lower in the rear without losing spring rate. Shackles are as long as they can go and I removed my load leaf for barely over 2" drop, then the rollpan and sparetire removal brought it back up to like 1.75 or 1.5"

putting the stock stuff back on and flipping the axle would be too much lowering compared to the front end..