Dakota Durango Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
Ok, so I picked up an 01 pt looser on the cheap that I'm in the process of fixing up and selling. I had to take the top part of the intake manifold off to get at the valve cover gasket. Now I've got it back together and it is acting kinda funny. It high idles fine for a couple minutes, but then once it goes to normal idle it runs really rough. Then when I tap the gas, it smoothes out but it jumps to about 3000rpm and stays there for a few seconds, even after i let off the gas, and then drops back to 1400 rpm and running rough. The car ran fine before I took it apart so I guess the question is what did I f*** up? :huh:
 

·
#19 ƃop ǝnןq ǝןʇ&#
Joined
·
13,196 Posts
Watch what ya say about PT Cruisers....we have an 03, bought it new...

Anyway....bet you messed up one of the intake plenum gaskets that is in between the upper & lower plastic pieces....or you either left off a vacuum hose that goes to the rear of the intake or it broke
 
1 - 3 of 3 Posts
Top