Dakota Durango Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
116 Posts
Discussion Starter #1
For anyone looking to put power seat in a truck that was not pre-wired for it, here is the male connector and about 8" of wire on the end. This was cut from the section that comes out of the floor and plugs into the female connector that is runs from the seat motor.

I pulled this from a junker when I was upgrading my DakotA to power leather seats. It turned out that my truck was pre wired (even though the seats it came with were manual), so I didn't need it.

Just send me $5 to cover postage.

ImageUploadedByTapatalk1355198539.790947.jpg
 
1 - 1 of 1 Posts
Top