Dakota Durango Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Today I was looking at building my own custom CAI using this one as a model for me to follow. So I printed the page and went out to my truck so I could compare their photos to my actual 4.7L engine bay. As I am looking at my engine I notice there is a square looking box sitting right in the middle of my engine bay. As I look around I notice there are some sensor wires running to this air box thing. What is this sensor, is it necessary? If I were to use this custom CAI would I need to install this sensor in the CAI or just let the sensor wires dangle?
 

·
Registered
Joined
·
13 Posts
Discussion Starter · #2 ·
Thanks but someone else ran across this problem or question over on dodgetalk and got an answer...

I guess its a air intake temperature sensor and if its not connected it will throw a Check Engine Light. Guess I'll put a hole in the pipe so its still completely functional.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top