[DurangoBeard]

So I have recently acquired a set of shorty headers and long tube. They are both for a chevy I believe . I noticed the grouping was similar to ours so had Autozone bring me a gasket and sure enough the ports weren't far off. He'll the center two lined up. Even the center two bolts holes too. The outside tubes were off by 1/2" in the back and maybe a 1/4" up front. I was thinking of just getting a set of flanges made and cut the old flange off. Little bend and weld and tada headers.

I'm posting to inform of my potential project and inquire if anyone else has tried this. Pics some time soon.

 

[Primus]

I believe someone may have tried this before but it has been years. IDK what some of problems could be if you go through with this because you are basically doing a custom set of headers at this point.