Dakota Durango Forum banner
1 - 6 of 6 Posts

· Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
i have an 03 r/t with the stampede kit on it wanted to know how low i should go and what kit to use,i don't want to slam it but just to fill in the wheel wells

Thanks, Joe
 

· Registered
Joined
·
728 Posts
hotchkis are expensive and for performance AND looks. if you`re only going for looks them just save a few hundred and get the djm drop.
the hotchkis isn`t for everyone. it`s a bit stiff of a ride for some people.
but if you want a bada$$ handling r/t then i`d go with the hotchkis.
 

· Registered
Joined
·
89 Posts
suffolk_mopar said:
hotchkis are expensive and for performance AND looks. if you`re only going for looks them just save a few hundred and get the djm drop.
the hotchkis isn`t for everyone. it`s a bit stiff of a ride for some people.
but if you want a bada$$ handling r/t then i`d go with the hotchkis.

Ditto

Hotchkis w/ 275/50/17 Nittos on 9.5 x 17 wheels
 
G

·
Sharper,that is one the best lookin slt's I have seen. :clap2: :drool:

Hotchkis is the only way to go.

Since you have a R/T you have the front and rear sways, You could get the leafs and springs seperate from summit and get some bilstein (sp?) shocks. :banana2:
 
G

·
If you are going for just the looks djm has a 3/5 lowering kit that would probably look killer on your truck...i put the 4/6 on mine...then i cut the bumpstops in front and now i'm bout to drop the back another inch and a half..due to the removal of my hitch and bumper..but hey it's all in what you like....ya know..lots of options..shop around and see what you can find....good luck
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top