Dakota Durango Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
1,075 Posts
Discussion Starter · #1 ·
Today i ordered my coils for my truck. The salesperson told that they would give me 1-1/2" lower in the front. I was looking more for around 2", and i think that will give me the best stance. Before ordering these, i questioned the salesperson about it. He suggested that i can trim 1/4 of the coil off to get the extra half inch. To me this sounds like a hack job, not sure what i should do. Thanks in advance
 

· Banned
Joined
·
12,273 Posts
First install and see where it puts you. Then if needed cut 1/8 of a coil at a time. Alot of guys run cut coils, even I at one time.
 

· Registered
Joined
·
1,075 Posts
Discussion Starter · #3 ·
awesome just what i wanted to hear, thanks rebel, i owe you some rep
 

· Banned
Joined
·
12,273 Posts
No problem. Just when you first install them and any test after, drive around a bit for them to settle in before you judge the height..
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top