Dakota Durango Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
499 Posts
NXNLINE said:
On the viper seats I used one inch square tubing and redrilled holes to line up,
honestly I have about five hours one each seat trying to hammer off the factory rivets that hold the seat tracks on. The B&M hammer is the chrysler model and was easy to install. There were some viper seats on ebay that sold for 680.00 last week like mine. I paid $1300.00 shipped to my door. I talked to a guy that installed seats like mine and left the stock seat tracks on and redrilled holes in his truck. Thats fine, but mine wont come loose if I hit someone. Send you pics when the 408 is installed!!! :drive:

Yeah, I did the same thing with the tubing. Was a little bit of a challenge for sure. Got mine off Ebay as well, $1200 shipped.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top