Dakota Durango Forum banner
1 - 1 of 1 Posts

· Administrator
12,575 Posts
BlackDak said:
This is from my 2001 owners manual...

1. Enter vehicle and close all doors.

2. Fasten seat belt. (This will cancel any chiming that may confuse you during this reprogramming procedure).

3. Place the key in the ignition.

4. Within 10 seconds, cycle the key from the OFF position to the ON position four times, ending in the OFF position. (Do NOT start the engine)

5. Within 30 seconds, press the drivers door lock switch in the LOCK position.

6. A single chime will be heard to indicate the feature has been disabled.

7. To reactivate, repeat the procedure.

8. If chime was not heard, program code was cancelled before procedure could be completed. Repeat procedure.
Did you actually try it. I read the same thing in my book and tried it like 15 times and I can't get it to work. :rant: :cussing:
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.