Dakota Durango Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
73 Posts
Discussion Starter · #1 ·
I just put in 4 new door speakers, a sub and a new deck. The sub and the deck are great but the rest of it sounds horrible. Anyways I have a set of component mids coming and i'm going to replace the front speakers and tweeters. I want to bypass the infinity amp and run them through my kenwood amp. So has anyone bypassed the amp and if so how did you do it.

tazz
 

·
Registered
Joined
·
73 Posts
Discussion Starter · #5 ·
here are the specs for the amp

kenwood KAC-8401

Key Features:

60 watts RMS x 4 at 4 ohms
90 watts RMS x 4 at 2 ohms
180 watts RMS x 2 bridged output at 4 ohms
2-, 3-, or 4-channel output
4-ohm stable in bridged mode
Tri-Way capable
requires 8-gauge power and ground leads wiring and hardware not included with amplifier
50-200 Hz high-pass/low-pass crossovers, 12 dB/octave
bass boost on rear channels (0/6 dB at 90 Hz)
cooling fan
preamp- and speaker-level inputs
preamp outputs
12-1/2"W x 2-3/16"H x 11-1/4"D


And yes they are coaxials in the door. Kenwood KFC1669S
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top