Dakota Durango Forum banner

FYI - Items to avoid purchasing

40430 Views 76 Replies 47 Participants Last post by  Letricblue
1) The Turbonator - the way air/fuel travels through the Magnum motor would probably cancel out any effect items like this would even remotely achieve.

2) Throttle Body Spacers - the way air/fuel travels through the Magnum motor would probably cancel out any effect items like this would even remotely achieve.

3) Any +hp "chip" from E-Bay/etc. They are just ten-cent resistors which replace the IAT sensor and attempt to fool the PCM into thinking the temperature of the air entering the engine is cooler or hotter than it really is, which supposedly slightly leans/richens the air/fuel mix going into the engine. Most of these people probably have no clue whatsoever what resistance value equals what temperature for the Dodge Dakota/Durango, and the mod itself does very little to begin with.
1 - 2 of 77 Posts
avoid any and all mopar products..
who makes front end wear parts that are " lubed for life"?
OR a fuel filter that is in the fas tank and is serviceable?
Nice job
It seems like my 2000 silverado, 1995 z28, and 2008 honda si are all though out better in their initial designs. The only compliant I have about my z28 is that the distrubuter is Crank driven and is under the water pump. but I have never had any problems with it.
There is even a vacuum line hooked into it to draw out any moisture that might collect
1 - 2 of 77 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top