Dakota Durango Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
hey guys Im finishing up doing an engine swap in my truck I took a 3.9 out of a 2wd 1500 96 and put it in my 4wd 98 Dakota iv switched everything that was different, except now I got under it this morning to put the torque converter bolts back in and no matter what hole I started with they would all go in except the last one.. its just a cunt hair high and I cant get the bolt started I was just wandering if anyone knew for sue that they were different before I take it all back out and switch that over to. also note: I dident tighted any of the bolts up all the way I just threaded um in enough to turn the flywheel.
 
1 - 2 of 2 Posts
Top