Dakota Durango Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
There is a 1" gap between the fender and bumper in the front and in the rear. I have a piece of molding to fill the rear, but is there any way to fill the front gap? I haven't looked too get yet, but maybe there's a way to raise the bumper or just shove something nice in there?

Has anyone filled these gaps?? They drive me nuts...
 

·
Registered
Joined
·
24 Posts
Discussion Starter #3 (Edited)
It all depends what it involves. I know enough to get by. If it's just moving some brackets around, that's great, but if it has to do with re-fiberglassing.. I'd rather not get into it. I'm looking for something relatively cheap.
What do you have in mind... and has it been done?

By the way.. AWESOME looking Durango! I love it!!!!
 

·
"Fuchengruhvin"
Joined
·
1,759 Posts
I think you are stuck with that ?. The brackets that they used from the factory have very limited adjustment capabilities - found that out when I did the body lift on mine.

If you think of a way, please share. I'm going to have to break down and take off both the front and the rear bumpers on mine to do a little "fitting"...again.
 
1 - 5 of 5 Posts
Top