Dakota Durango Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
876 Posts
on the back of the door panel you'll see several round spots around the edge of the carpet line. looks like melted plastic or like a plastic weld(sorry dont know how to better describe them. someone will chime in) i took my dremel tool and you just grind them out around the outside. dont go too deep. maybe set the depth at 1/4''. try and keep the center in tact because then you can use small screws and washers to reinstall them
 

·
Registered
Joined
·
876 Posts
it's held on with plastic rivets... you have to grind the backs off carefully and then pop the panel out.

To re-install it pop the panel back into the door and carefully re-attach using small wood screws and washers into the hollow shafts that remain from the rivets

there ya go
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top