Dakota Durango Forum banner

Dash Kit

13491 Views 43 Replies 12 Participants Last post by  01KotaQuad
So I've done engine, exterior and minor interior work to my Dak. I have big dreams for my truck but i think right now i need something interior stuff to be done. So what do you think of these Dash kits? What would look best in my cab? Does anyone have picture? If you think i should leave it alone cause it is clean well tell me that! haha this picture fails to show my JVC deck.

Land vehicle Vehicle Car Minivan Sedan
See less See more
1 - 3 of 44 Posts
Kit was backordered for some time. Finally came in and I was a bit surprised as it said "real carbon fiber" .....flat, stick on rubbery stuff....hemmed and hawwed about whether to put on or not....Here it is installed. If anyone can point to a "real molded carbon fiber" kit, would really appreciate it! Ordered this believing it was molded :( have never seen rubber "real carbon fiber" :(
That said....I think it added some to the look, far from what I was expecting, but still an addition at this point.
Looks good on the center stack around the radio!

Everywhere else...eh.
Those kits r always junk, how bout some suede door inserts, chrome around the gauges, nice gauge upgrade and some polished a c knobs...
Where did you get this gauge face? I like it!!
I can paint the dashes too
Is that suede on the airbag cover?

If so...You may want to be careful with covering the airbag - (I know it doesn't seem like it, but) lots of work goes into the design so that the cover splits at the right place and with the right amount of resistance to allow the airbag to inflate correctly and quickly.

Just an FYI.
1 - 3 of 44 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.