Dakota Durango Forum banner
1 - 5 of 5 Posts

·
Low 'N Slow
Joined
·
635 Posts
Discussion Starter · #1 ·
So i need to lower my 2.5 a bit more, never liked the idea of cutting coils, but im doing my lower ball joints so i might as well. I want to know, how much to cut? i only need like an inch drop. thanks.
 

·
Banned
Joined
·
25,820 Posts
Cut a quarter of a coil on both springs, then if needed cut 1/8 at a time after until you reach desired height.
 

·
Low 'N Slow
Joined
·
635 Posts
Discussion Starter · #3 ·
only thing is i dont want to have to do it multiple times... cause it is a total PITA to keep pulling the spring out everytime
 

·
Banned
Joined
·
25,820 Posts
You may have to. Not all coils act the same. Alot of people said 1/2 works. It didn't for me, took about 3/4. I pulled my coils probably a dozen times since I had this truck, it's not bad as long as you have a puller for the ball joints.
 

·
Low 'N Slow
Joined
·
635 Posts
Discussion Starter · #5 ·
I guess ill give it a shot.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top