Dakota Durango Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
129 Posts
if you want a lopy idle you want to stay with something along the lines of a 110-112 degree lobe center. Plus what cam you want depends on where you want your power to be. If your looking for something pretty lopy your probably going to have to sacrafice some low end power. Give Sam at So Cal a call or give Dan Arcand from Fastman a call. They both have some good grinds.
 

·
Registered
Joined
·
129 Posts
rtdkota said:
www.socaldakota.com/gallery/videos/20040515/Houston Feb 2005.wmv

:drive:


3 mph faster, 3/10ths quicker with only a cam and spring change (stock heads).

Sam
www.socaldakota.com
619-274-1292
:clap2:
Hey Sam i was wondering what a new cam grind would cost me? I've got the M1 52mm throttle body, Mopar PCM, MSD ignition, Mopar Headers 3" exhaust (no kitty cat). My profile says the other stuff. Oh and i'm runnin a 100 shot of nitrous occasionally but not often. I am plannin on gettin a set of 1.92 R/T heads. What grind do you have that will give me some good power. Oh i'm plannin on gettin 1.6 rr's and all the essentials of course.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top