Dakota Durango Forum banner
1 - 1 of 1 Posts

·
99 Durango 5.9 part out
Joined
·
1,252 Posts
Discussion Starter · #1 ·
I got a reman compressor 11cfm 60gal. The fitting on the side of the tank is 1/2", I wasn't really paying attention and ordered a 1/4" hose reel. I can take it back tomorrow and trade up to a 3/8" or 1/2" but just wondering how bad the 1/4" would bottleneck. The biggest sucker I've got is a snapon 1/2" impact that'll take 10cfm @100psi.

I'm also wondering if I need to get a regulator/filter filter/oiler something of that nature. Does the filter/oiler eliminate the need to oil the tools, while removing the water at the same time? Cost is an issue

I'll be going to northern to return the hose
or

Or for $20 less I make an extra stop at harbor freight just down the street.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top