Dakota Durango Forum banner
1 - 12 of 12 Posts

·
10 Second Club
Joined
·
4,009 Posts
Discussion Starter · #1 ·
Anyone have one out that they can measure? I want to see if the one from the 727 will be fairly close since I have to get a locking one. If I can get the length of the stick where it hits the tube to the end. and then the length of the tube itself. Thanks.

PS, I don't have my truck right now or I might be able to do it myself. If someone can get them out of the vehicle it would be a little more accurate. Thanks.
 

·
Pre-Teen Giggle Brigade
Joined
·
6,840 Posts
on the tube u want the end to end or u want me to follow the curve and go end to end?
 

·
10 Second Club
Joined
·
4,009 Posts
Discussion Starter · #5 ·

·
Pre-Teen Giggle Brigade
Joined
·
6,840 Posts
about 33.5 inches


the dipstick i lost so idk about that haha

dipstick is the same for a 44re also
 

·
10 Second Club
Joined
·
4,009 Posts
Discussion Starter · #9 ·
about 33.5 inches


the dipstick i lost so idk about that haha

dipstick is the same for a 44re also
Damn that is long as shit. Are the Durangos and Dakotas the same? The 727 one is only 21 inchs or so.
 

·
Pre-Teen Giggle Brigade
Joined
·
6,840 Posts
i wouls assume its the same. same motor and trans and firewall
 

·
10 Second Club
Joined
·
4,009 Posts
Discussion Starter · #11 ·
Yea but I am wondering about the height of the drivetrain. But I guess it would be the same or otherwise the engine would look more sunk in in the engine bay. hmmm
 
1 - 12 of 12 Posts
Top