4.7 to 5.9 swap from wrecked durango to new

2439 Views 8 Replies 5 Participants Last post by nwrensch, Feb 25, 2021

MoparDude91

Discussion Starter · Feb 18, 2021

Alright so I'm not a complete noob, I have even around Dodge a good part of my life. I'm a Mopar fantaic. I know what I'm doing just trying to find some info out.

I am doing a motor swap on my new Durango which came with the 4.7 (crappy motor) and was blown. I am swapping in my brand new 5.9L motor along with my rebuilt 46RE tranny that doesn't even have 30K on it. I am trying to find out what all I need to do on the swap I have everything I need since I have my old Durango and everything minus the frame and bent front axle are still good. I have pcm, wiring harnesses, etc. I need to know if there is anything special I need to change on the 02 that had the 4.7. Like anything on the inside, or any of the major components. I'm trying to add in some of the thing I had in my 00 Durango which is the SLT or SLT+ (the VIN kept saying different thing each time it was input.). The 02 Durango is an SLT as well but doesn't have some of the same features or opitions as the 00 does. Any help is appreciated!

P.S the comments about how this swap is dumb or not worth it ARE NOT NEEDED! IM DOING THE SWAP ANYWAYS.

Save

1 - 1 of 9 Posts

nwrensch

· #9 · Feb 25, 2021

MoparDude91 said:
My 02 is a JTEC it only has 3 plugs, it was a realier 02 build. but here's the issue i just ran into, the 5.9 engine wiring harness will not plug into the 4.7 underhood fuse box. 2 different connectors, so im guessing that would be the pin out i need? or do i need to take the fuse box wiring harness out and switch it for the 5.9 fuse box wiring harness? which if that be the case then there is another connector issue including the security box on the drive kick panel. Im trying to inagrate the the 5.9 features like the MPG and Compass that are on the over head console into the bare bones SLT 4.7 body doesnt have. I didnt think i was gonna have wiring issues because i had assumed that all the harness's were the exact same. ( Wiring is not my fortai). and i have 3 computers I have the orignal 5.9 Computer out of my wrecked 00 DDurango, I have a computer that I pulled out of an 01 Durango 5.9 that was in the junkyard, and i also have the 4.7 computer that was the orignal to the 02, all are 3 plug, 2 are 5.9 and 1 is 4.7, which would would i have to have programed Im guessing or re-flashed? or which one should i use?

you will have to change the harness for engine and trans, it is all different, injection is a batch system on the 5.9 and and uses one coil and a distributor. sequential fuel injection and coil pack for the 4.7, and the transmission controlling is all different. A lot of work here

Save

1 - 1 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month