Dakota Durango Forum banner

2001 Dakota break line help

1742 Views 0 Replies 1 Participant Last post by  Shawnbennett97
I have a 2001 Dodge Dakota. Like most, my break lines are completely rusted and given out on me a few times so I have been replacing them but by bit. I am now replacing the rear brake lines that go from the hose block to the wheel cylinders. I have been using 3/16 lines up until this point. For some reason my 3/16 lines do not fit into the wheel cylinders. I have tried several things but I am still unsure of what to do. My dad recommends trying to buy pre bent lines and that just seems to cost a ridiculous amount of money. Anyone know why my lines do not fit into the wheel cylinders? They have the same flair and are fully threaded.
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top