Search Results for ‘#pleasehelp’

So a few months ago, my heat started only blowing on high. I did my research and replaced the blower motor resistor. It fixed the problem, about two months later, it happened again, and I replaced it again. After about a week it’s now gone out again? What else could it be besides the resistor?

When engine/transmission are cold, in drive and stopped sometimes the truck decides to engage first and try to move forward when I'm not pressing on the gas. No the pedal is not sticking. If I stand on the brakes to make sure it doesn't move it stalls out. If I'm light on the brakes rpms drop...

I have a 06 AWD dakota slt 4.7 H.O and at just over 100k on it and started getting a cylinder 4 misfire so changed my plugs with 5 from the other side and it switched to cylinder 5. problem solved I thought coil or plug was bad. Replaced the coil and went for a drive ran great. Next time...

I recently purchased an 01 dakota 4.7 4x4 and blew the head gasket. I then bought a used engine 4.7 lined up perfectly I swapped the flywheel and other necessities. I have e reason to believe the engine I purchased came from a durango it will not start and I've tried everything I can think of...

So I have a 2003 Durango 4.7 liter 4x4 automatic transmission. I recently replaced my rotors calipers pads caliper hoses and brake lines all around everything brand new. I have absolutely no leaks anywhere in any of the fittings lines hoses or junctions. When I bleed my brakes the pedal gets...