Dakota Durango Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Items For Sale
    I have my Built 4.7 for sale. It is an 07 model from a Chrysler Aspen bored .040 over, Scat I-beam Rods, Ross forged racing pistons 10:1 compression. ARP head studs, stainless copper coated 3 layer head gaskets, ATI super damper, Cloyes bearings, I have still new in the box Comp cams beehive...
  2. 4.7L/4.7L HO/4.7L Gen II Engines
    Just did a complete engine rebuild on the 4.7l. Tried to start her over today and found I need a fuel pump. Truck sat for 9 years so I can see why. Anyway, I rebuilt the engine top to bottom so I was looking at the oil pressure gauge religiously when I was cranking and wasn’t moving at all. Will...
  3. New Member Introductions
    What can I do to get better mpg? I get 10-14 at best right now I have done no upgrades to it other then radio and sound system just started to do my own work on my rango. Dont got deep pockets at this time.
  4. Suspensions - Lifted & Lowered
    Recently got this this truck off the auction but the front end sits very low there is only 1 inch between the tire and fender. The rear end sits high and normal. It has new lower control arms and the torsion bars has been cranked all the way up. Please any dodge techs that specialize in 01...
  5. New Member Introductions
    I bought these crap o2 sensors from Amazon n they kept throwing codes. I just bought o2s from the factory n I have the wrong item number. I have a 2004 Dodge Durango 4.7 SLT. My bank1-sensor1, bank2-sensor1, and bank2-sensor2 part number is 56028998AA. For my bank1-sensor2 the part number is...
  6. General Parts Inquiries
    Ok, so I have a 2002 durango slt 4.7l and the power stud snapped off on my starter. Can I get a new one and do a rebuild? Also wondering if the starter from a 98 durango 5.9l would fit on my 2002 4.7. I’ve looked online and I’ve seen two different starters one has a power and ground stud and one...
1-6 of 6 Results