Dakota Durango Forum banner

Brake Switch Signal 1 and 2 question

2K views 4 replies 3 participants last post by  derek502 
#1 ·
How to I get this to work? The Dakota brake switch only has 1 circuit?
 
#3 ·
Thanks, I have Brake Switch Signal 1 connected to the 5.7 ECM and it's on a ground signal. I think Brake Switch Signal 2 is looking for 12v, right?
 
#5 ·
I found out that Brake Switch 2 needs to supply +12v to the Ram ECM. This circuit is a ground signal on the Dakota.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top