2003 Durango R/T with built motor - Dakota Durango Forum
Vehicles For Sale Post an ad to sell your vehicle here.

 
Thread Tools Rate Thread Display Modes
post #1 of 6 Old 01-18-2017, 11:22 PM Thread Starter
NXNLINE
Will Race For Food


 
NXNLINE's Avatar
 
Join Date: Aug 2004
Location: Middleburg, Fl
Vehicle: 2003 Durango R/T 5.9
Modifications: stock
Posts: 1,294
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
 
2003 Durango R/T with built motor

Hey guys, I am selling my 2003 Durango R/T. It has newly built motor and rebuilt transmission.
I am sure there are pictures of this build under a thread I started here 2 years ago (http://www.bionicdodge.com/bionic/in...?topic=12879.0)

Motor:

Mopar 2.02 R/T Iron Heads that have been fully ported.
Comp Cams 1.7 Roller Rockers
HiPoTek HPT 210X4 4x4 210/214 .506/.506 11
Sealed Power H-Rods
Keith Black KB232-030 Hypereutectic Dish Pistons 4.030 Bore with molly file to fit rings
Air Gap Intake
HiPotek 52 TB
HiPotek fuel rails
Double Roller timing
Spintechs Headers
Mopar Jeep Valve covers, eveything has been powder coated, all brackets, intake,

Trans:
Rebuilt and has Hipotek 2800 converter

SCT with Hemifever tune
Full 3" mandrel bent exhaust into Flowmaster 50 series for SUV

The bad, the truck needs to be recleared, long story short, had a buddy who owed me money, said he would paint truck, paint came out great, but the clear has runs in it, he recleared the truck 3 times in the winter and I go fed up and pulled the truck from him to finish built. I have installed dyna mat all under neath the carper. The front drive shaft is removed, it makes noise when installed. I did order a new driveshaft that has the u joint conversion on it. I have been thru 2 PCMs, I lose the firing on the coil. Spoke to Hipotek, says the MSD coil would not cause this, i have been all over the wiring harness and can't find any cuts, shorts, or pinched from the engine install. I have purchased another pcm that also came with SCT hand held, but the truck starts and then shuts off, I assume its something with security on the pcm. I have not installed stock coil back on and ran that way, I even ran a dedicated ground from the battery to the pcm bracket.

All in all, the truck is just sitting in my drive way for about a year and I just bought a house and need money. I don't want to part out the truck, I am asking $4500 firm. I have more that this in the build alone. Please dont bug me with low ball offers. I have the complete build sheet and all receipts from Hipotek. I ordered about 90% of the parts from him. I installed a wideband that mounts on the column, I am sure I am not listing everything, the truck does have the sniper bumper and grille on it. LED tail lights. I have lowered it 2" and has chrome r/t wheels. The truck is red, I will post pics tomorrow, I just wanted to see if there is any interest. I can be reached faster at tompotts@juno.com. I posted a link above on the build and you can look at the pics, the motor has about 2000 miles since rebuild. If anyone just wnats the truck minus the motor, I am wlilling to remove engine and sell truck as is.

Put your money where your mouth is " BITCH "

2003 Durango R/T, SCT tuned by Hemifever, K&N cold air, upgrades coming soon!
NXNLINE is offline  
Sponsored Links
Advertisement
 
post #2 of 6 Old 01-26-2017, 06:36 PM
Leroy R/T
MADR/T Member
 
Leroy R/T's Avatar
 
Join Date: Jul 2007
Location: Georgia
Vehicle: 2003 Dakota R/T
Modifications: M1, Fastman TB, Tune, Saine built trans.
Posts: 741
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
 
I'm slightly interested. Been looking for an R/T Durango for a little while. Just not sure I want one that heavily modded. Found a stock one in NC but they want nearly 9k.

Someday, someone may kill you with your weapon. But they're going to have to beat you with it because it should be empty.

I'm looking for 4-wheel abs parts, and a K&N round filter kit for a Dakota. PM me if you know where I can get them.
Leroy R/T is offline  
post #3 of 6 Old 01-29-2017, 04:42 PM Thread Starter
NXNLINE
Will Race For Food


 
NXNLINE's Avatar
 
Join Date: Aug 2004
Location: Middleburg, Fl
Vehicle: 2003 Durango R/T 5.9
Modifications: stock
Posts: 1,294
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
 
Let me know, the cam is not a big cam and Richard at Hipotek can verify that when I discussed building the motor, it was built for everyday driving, in all, the cam should of been bigger for the heads that are on it, keep me posted, I am in no hurry, if I still have it by end of next month, I will remove engine sell truck as roller and keep motor for a rat rod project.

Put your money where your mouth is " BITCH "

2003 Durango R/T, SCT tuned by Hemifever, K&N cold air, upgrades coming soon!
NXNLINE is offline  
 
post #4 of 6 Old 04-21-2017, 02:50 AM Thread Starter
NXNLINE
Will Race For Food


 
NXNLINE's Avatar
 
Join Date: Aug 2004
Location: Middleburg, Fl
Vehicle: 2003 Durango R/T 5.9
Modifications: stock
Posts: 1,294
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
 
I want this gone, lets make a deal!

Put your money where your mouth is " BITCH "

2003 Durango R/T, SCT tuned by Hemifever, K&N cold air, upgrades coming soon!
NXNLINE is offline  
post #5 of 6 Old 05-28-2017, 03:37 PM Thread Starter
NXNLINE
Will Race For Food


 
NXNLINE's Avatar
 
Join Date: Aug 2004
Location: Middleburg, Fl
Vehicle: 2003 Durango R/T 5.9
Modifications: stock
Posts: 1,294
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
 
Pics added

Here are some pictures ! The truck is running, just installed a new PCM!
Attached Thumbnails
Click image for larger version

Name:	RT Driver Side.jpg
Views:	18
Size:	273.6 KB
ID:	101602   Click image for larger version

Name:	RT Engine Drivers Side.jpg
Views:	16
Size:	186.1 KB
ID:	101610   Click image for larger version

Name:	RT Engine Front.jpg
Views:	18
Size:	228.4 KB
ID:	101618   Click image for larger version

Name:	RT Engine Passenger Side.jpg
Views:	15
Size:	193.8 KB
ID:	101626   Click image for larger version

Name:	RT Fog Lights.jpg
Views:	15
Size:	333.0 KB
ID:	101634  

Click image for larger version

Name:	RT Front.jpg
Views:	14
Size:	221.9 KB
ID:	101642   Click image for larger version

Name:	RT Interior.jpg
Views:	14
Size:	155.8 KB
ID:	101650   Click image for larger version

Name:	RT Passenger Side.jpg
Views:	14
Size:	256.0 KB
ID:	101658  

Put your money where your mouth is " BITCH "

2003 Durango R/T, SCT tuned by Hemifever, K&N cold air, upgrades coming soon!
NXNLINE is offline  
post #6 of 6 Old 06-03-2017, 04:07 PM Thread Starter
NXNLINE
Will Race For Food


 
NXNLINE's Avatar
 
Join Date: Aug 2004
Location: Middleburg, Fl
Vehicle: 2003 Durango R/T 5.9
Modifications: stock
Posts: 1,294
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
 
Truck is sold!

Put your money where your mouth is " BITCH "

2003 Durango R/T, SCT tuned by Hemifever, K&N cold air, upgrades coming soon!
NXNLINE is offline  
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Dakota Durango Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in









Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



User Tag List

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes Rate This Thread
Linear Mode Linear Mode
Rate This Thread:


Forum Jump

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome