Hi all, thanks in advance.
I've got a stumble that feels like a miss, most noticeable on the highway.
I've got no codes.
I had similar miss last year and replaced crank position sensor, i replaced again and did not fix problem this time.
I have set of wires I'll put on, see if that helps.
I did cap and rotor last year when I was trying to fix the stumble last year.
I've been doing some reading, I'm hoping not compression related. After wires I'll check pugs and when I have them out I'll check compression.
Any thoughts much appreciated.
Thanks,
joel
I've got a stumble that feels like a miss, most noticeable on the highway.
I've got no codes.
I had similar miss last year and replaced crank position sensor, i replaced again and did not fix problem this time.
I have set of wires I'll put on, see if that helps.
I did cap and rotor last year when I was trying to fix the stumble last year.
I've been doing some reading, I'm hoping not compression related. After wires I'll check pugs and when I have them out I'll check compression.
Any thoughts much appreciated.
Thanks,
joel