Looks like I'll be usint the nitrous...

[DanDB64]

Yeah.. My problem will be the plastic intake thing... Its a wet kit, most i will go is probably 75... Any tips on how to not blow my stuff up? I plan on taking my old TB spacer, drilling 2 holes in it and inject the nitrous that way...

[viperkota]

i'm not very experienced with no2, but i have read people saying that our plastic intake tends to "puddle" which has possibly been the cause of several intakes blowing apart. i was looking in the direct port injection. lot of work but seem to be safer. anyone else got an opinion on this?

[Slow97dakota]

Yeah.. My problem will be the plastic intake thing... Its a wet kit, most i will go is probably 75... Any tips on how to not blow my stuff up? I plan on taking my old TB spacer, drilling 2 holes in it and inject the nitrous that way...
if its a NX kit they tell ya to put it 6 inches away from the tb, take the spacer off and put the nozzel obviously 6 inches away, helps the fuel and air mix better. if you dont have 1 already get a 180 thermo and run 1 step colder plugs. if you have any mods that advance the timming, take it off. other then that have fun, make sure the bottles warm. for safteys sake i say the first time u spray the truck having it be on a dyno with a a/f sniffer in it and make sure its between 11:1-12:1. work ur way up threw the jets. when ur done on the dyno pull the plugs to make sure. i think thats it

[RyanWJ]

dont spray it at low rpms. that's a good way to get it to pool up in the intake manifold.

[DanDB64]

Sweet, thanks guys... I'm gonna give this a shot, not until spring though, because winter+n2o=????

And there is a dyno semi-local to here, so I'll set up a date for the early spring...

[Ace]

so did u ever find out exactly how many ppl have detonated? must have not been that bad